Welder

• Monitors blow molding machine by pushing buttons.
• Removes plastic parts from machine by hand. May be required to use step(s) to enter machine or work platform.
• Removes flash (excess plastic) from parts.
• Inspects parts for defects.
• Monitors quality of product and notifies process techs, and/or quality.
• Weighs parts as required in work instruction.
• Allows flash to cool and grind.
• Grind defective parts.
• Performs secondary operation per work instruction.
• Follows instructions as shown on the work instruction.
• Logs in and logs out of the Shop Floor Monitoring System at the start of the shift, before and after each break period and at the end of the shift.
• Enters rejects into the Shop Floor Monitoring System.
• Packages production parts as shown in the work instruction.
• Maintains effective communication with the Process Tech, Production Supervisor, Plant Manager and other members of Management
• Must be able to comprehend and carry out oral and written instructions.
• Must be able to perform all production tasks while following the procedures outlined in the work instruction
• Must maintain a clean, organized, and safe work area at all times.
• Other duties as required

Must support the Environmental Policy through demonstration of Awareness, Commitment, and Execution.

To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed are representative of the knowledge, skill and/or ability required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.

Send resume to: This email address is being protected from spambots. You need JavaScript enabled to view it. (subject "Shipping and Receiving") or apply online at the link below.